Forklift Load Center & Capacity Calculator

Check a forklift lift before you make it: the load’s actual load center, the truck’s reduced capacity, whether it’s overloaded, and how hard you can brake or turn before the load tips off the forks.

Usually 24 in on U.S. trucks; 500 or 600 mm on metric trucks.
0 if the load is pushed fully back against the carriage.
For an evenly packed stack, half its height.

Results

Verdict
76.8% of capacity — within the rating
Actual load center
600 mm
Capacity at this load center
2,083 kg
Load moment used
76.8% of the truck’s maximum
Braking: load tips at
0.8 g — you brake at 0.252 g
Turning: load tips at
0.667 g — your turn makes 0.252 g
⚠️ The load center (600 mm) is beyond the rated 500 mm, so capacity is reduced to about 2,083 kg.
💡 The load-center rule (rated capacity × rated load center ÷ actual load center) is the simplified method in OSHA’s forklift eTool. Always follow the truck’s data plate and the manufacturer’s load chart, which also cover lift height and attachments.
💡 Load tipping assumes a rigid, unsecured load that doesn’t slide first. Shrink-wrapped or strapped loads hold together better; loose stacks can shift at lower accelerations. The truck itself can tip sideways in a fast turn even when the load stays put.

Formula

Load center = gap + distance to the load’s center of gravity; capacity at that load center ≈ rated capacity × rated load center ÷ actual load center; load tips on the forks when acceleration ÷ g > (CG distance to edge) ÷ (CG height)

Rules of thumb

  • Heavy end toward the mast, load pushed fully back, forks spread wide and centered, travel low with the mast tilted back.

More Everyday calculators