Paver & Patio Calculator

Plan a paver patio or walkway: number of pavers, tons of gravel base, bedding sand, edge restraint and polymeric sand, with a cost estimate.

4–6″ for patios and walkways; 8–12″ for driveways.
%

Results

Patio area
192
Pavers
951
Gravel base
2.37 yd³ ≈ 3.32 tons
Bedding sand
0.593 yd³ ≈ 0.8 tons
Edge restraint
56

🛒 Shopping list

ItemQtyPrice each ($)Cost
4″ × 8″ pavers 951 pavers$665.70
Crushed stone base (¾″ minus), bulk Or ≈ 128 bags of 0.5 ft³4 tons$180.00
Concrete / bedding sand, bulk Or ≈ 32 bags of 50 lb1 tons$50.00
Paver edge restraint, 8 ft + spikes 7 pieces$84.00
Polymeric joint sand, 50 lb 4 bags$120.00
Landscape fabric (3 × 50 ft roll) 2 rolls$40.00
Estimated materials total$1,139.70

Prices are rough US starting points, not quotes — type in your local store’s prices. Taxes and delivery not included.

💡 Tons are for bulk delivery (crushed stone ≈ 1.4 t/yd³, sand ≈ 1.35 t/yd³). Compacted base needs about 20% more material than its finished depth — order a little extra.
💡 Call 811 (or your local utility-locate service) a few days before digging — it’s free and required in most places.

How to do it

Difficulty: ModerateTime: 2–3 weekends

Tools you’ll need

  • Shovel & wheelbarrow
  • Plate compactor (rent)
  • Screed rails (1″ pipe) & a straight 2×4
  • Masonry saw or splitter (rent)
  • Rubber mallet
  • String line & line level

Steps

  1. Call 811 (or your local utility-locate service) a few days before digging — it’s free and required in most places.
  2. Mark the area, excavate to base depth + sand + paver thickness, and slope it ⅛–¼″ per foot away from the house.
  3. Lay landscape fabric, then spread and compact the gravel base in 2″ layers with a plate compactor.
  4. Screed 1″ of bedding sand flat over pipes — don’t compact it.
  5. Lay pavers from a straight edge in your pattern without walking on the sand; cut the edge pieces.
  6. Install edge restraint, compact the pavers, sweep in polymeric sand, compact again and mist it to set.

Common mistakes

  • Skimping on base depth or compaction — pavers sink and rock.
  • No slope — water pools against the house.

Formula

Pavers = area × pavers per ft² × (1 + waste); base gravel tons = area × depth × 1.4 t/yd³; sand tons = area × 1″ × 1.35 t/yd³

More DIY Projects calculators

← Browse DIY projects