Roofing Shingles Calculator

How many bundles of shingles do you need? Calculate roof area from footprint and pitch, squares, bundles, ridge cap, underlayment, drip edge and nails.

/12
Inches of rise per 12″ of run. Use the roof pitch calculator if unsure.
%

Results

Roof area
1,341.64
Squares (100 ft²)
13.4
Shingle bundles
45
Ridge & hip cap length
40
Drip edge length
147.082

🛒 Shopping list

ItemQtyPrice each ($)Cost
Architectural shingles 45 bundles$1,890.00
Ridge cap shingles (≈ 25 lf per bundle) 2 bundles$120.00
Starter strip (≈ 110 lf per bundle) 2 bundles$80.00
Synthetic underlayment (1,000 ft² roll) 2 rolls$220.00
Ice & water shield (≈ 65 lf × 3 ft roll) Along the eaves (required in cold climates)2 rolls$240.00
Drip edge, 10 ft 16 pieces$160.00
1¼″ coil roofing nails (box ≈ 7,200) 1 boxes$60.00
Estimated materials total$2,770.00

Prices are rough US starting points, not quotes — type in your local store’s prices. Taxes and delivery not included.

💡 Hip roofs, valleys and dormers waste more — use 15% instead of 10%.
💡 Pitch 6/12 = 26.6°; each slope is 1.118× the flat footprint.

How to do it

Difficulty: AdvancedTime: 2–5 days for a house (with helpers)

Tools you’ll need

  • Roofing nailer + compressor
  • Roof harness, rope & anchor
  • Roof jacks & planks
  • Utility knife with hook blades
  • Chalk line
  • Pry bar / tear-off shovel

Steps

  1. Check the weather window and permits; order a dumpster for the tear-off.
  2. Tear off the old shingles and underlayment down to the deck; replace any soft or rotted sheathing.
  3. Install drip edge on the eaves, ice & water shield along the eaves, then underlayment, then drip edge on the rakes.
  4. Nail a starter strip along the eaves and rakes.
  5. Snap chalk lines and lay shingles from the bottom up, 4 nails each (6 in high-wind areas), offsetting the joints.
  6. Flash around chimneys, walls and vents, then finish with ridge cap shingles.

Common mistakes

  • Nailing above the nail line — shingles blow off.
  • Skipping ice & water shield at the eaves in snow country.
  • Re-using old step flashing.
👷 When to call a pro: Falls from roofs are one of the most common causes of serious DIY injury. For steep (over ~7/12) or two-storey roofs, hire a licensed roofer.

Formula

Roof area = footprint × √(1 + (pitch/12)²); squares = area ÷ 100 ft²; bundles = squares × 3 × (1 + waste)

More DIY Projects calculators

← Browse DIY projects