Deck Calculator

How many deck boards, joists, hangers and screws do you need? Enter your deck size to get a shopping list, a material cost estimate and step-by-step building tips.

%

Results

Deck area
192
Deck boards
29 × 16 ft
Rows of boards
26
Joists
13 × 12 ft (2x8)
Deck screws
≈ 676

🛒 Shopping list

ItemQtyPrice each ($)Cost
5/4×6 PT deck boards, 16 ft 29 boards$649.60
2x8 PT joists, 12 ft 13 boards$249.60
2x8 PT ledger & rim joist, 16 ft 2 boards$51.20
Joist hangers (2x8) 13 hangers$26.00
Deck screws, 2½″ (box ≈ 350) 2 boxes$76.00
Ledger flashing tape / Z-flashing 2 rolls/pieces$50.00
Estimated materials total$1,102.40

Prices are rough US starting points, not quotes — type in your local store’s prices. Taxes and delivery not included.

💡 Posts, beams and footings are not included — they depend on deck height and your local code. Use the post hole concrete calculator for the footings.
💡 Boards span the full length — no butt joints needed.

How to do it

Difficulty: AdvancedTime: 2–4 weekends

Tools you’ll need

  • Circular saw & miter saw
  • Drill / impact driver
  • 4 ft level & string line
  • Post-hole digger or auger
  • Speed square & tape
  • Safety glasses & hearing protection

Steps

  1. Check permits, setbacks and HOA rules. Call 811 (or your local utility-locate service) a few days before digging — it’s free and required in most places.
  2. Attach a ledger board to the house rim joist with structural screws or lag bolts, with flashing above it to keep water out.
  3. Lay out the footings with string lines (check square with the 3-4-5 method), dig below the frost line and pour the footings.
  4. Set posts and beams, then hang the joists from the ledger with joist hangers at your chosen spacing.
  5. Install decking with an even gap, screwing twice into every joist; stagger butt joints and land them on a joist.
  6. Add stairs and a railing — most codes require a guard when the deck is more than 30″ above the ground.

Common mistakes

  • Skipping ledger flashing — the #1 cause of rotted rim joists and deck collapses.
  • Butt joints that don’t land on a joist.
  • Using nails instead of joist-hanger nails or structural screws in hangers.
👷 When to call a pro: Attached decks carry heavy loads and are a common cause of injuries when they fail. Most places require a permit and inspection — and a pro for decks high off the ground.

Formula

Rows = depth ÷ (board width + gap); decking ft = rows × length; joists = length ÷ spacing + 1; screws = 2 per board per joist

More DIY Projects calculators

← Browse DIY projects