Drain Pipe Slope Calculator

Calculate drain pipe slope: total fall for a run at ¼″ or ⅛″ per foot, percent grade, and the minimum slope required by plumbing code for each pipe size.

Results

Total fall
5
Slope used
0.25″ per ft (2.08%)
Code minimum for this pipe
0.25″ per ft
Drain pipe sizeMinimum slope (IPC Table 704.1)
2½″ or smaller¼″ per foot (2%)
3″ to 6″⅛″ per foot (1%)
8″ and larger1/16″ per foot (0.5%)
💡 Minimums are from the International Plumbing Code; the Uniform Plumbing Code is similar. Check your local code, and keep fixture trap arms within their maximum length.

How to do it

Difficulty: ModerateTime: 1–3 hours per run

Tools you’ll need

  • Torpedo level (with ¼″/ft bubble mark) or 4 ft level
  • String line & line level
  • PVC/ABS saw & deburring tool
  • Primer & solvent cement
  • Pipe hangers / straps

Steps

  1. Measure the run from the fixture’s trap arm or drain to the stack or main.
  2. Calculate the total fall with this calculator and mark the high and low points.
  3. Stretch a string between the points to show the slope; hang straps every 4 ft (PVC/ABS) along it.
  4. Dry-fit the pipe, check it with a level — the bubble should sit just off center toward the high end — then glue it.
  5. Run water and check for leaks and steady flow.

Common mistakes

  • Back-pitch or flat spots (“bellies”) where water and waste sit.
  • Using a ¼″ bend where a long-sweep fitting is required.
👷 When to call a pro: New drains and venting usually need a plumbing permit and inspection.

Formula

Total fall = slope (in per ft) × run length (ft); grade % = slope ÷ 12 × 100

More DIY Projects calculators

← Browse DIY projects